Aquarium Hose Holder for Water Changes, Tank Rim Hose Clamp

During a water change the hose slips out of the tank the moment you let go. This clamp holds it at the rim, whether you're draining or refilling. That leaves both hands free for the bucket, the net, or whatever else needs doing.

Fitting

Two clamps with knurled screws, both tightened by hand without tools. The lower one grips the rim of the tank and adjusts continuously, so it fits any glass thickness. The upper one holds the hose.

Hose diameter

Anything from thin RO tubing up to 12/16 mm fits comfortably. A 16/22 mm hose can still be clamped, but it's a tight fit.

Material

Printed in PETG. Water-resistant and dimensionally stable, even with constant water contact. PLA softens over time and turns brittle, which is why I don't use it for aquarium parts.

Colours

Black, Grey

About the finish

I print every part in Germany, check each one myself and pack it by hand. The fine lines on the surface are part of 3D printing, not a defect.

Prices shown are total prices. VAT is not charged under the small business regulation (§ 19 UStG, Germany).